Engineering, 23.03.2020 23:40, JackMonhen

A rectangular steel eyebar 3/4 inches thick and 24 ft long between centers of end pins is subjected to an axial tensile load of 50,000 lb. If this bar must not elongate more than 0.20 inches, calculate

(a) the width of the bar and
(b) tensile stress developed at maxium elongation, using required width calculated in (a)

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Engineering, 04.07.2019 19:10, santosbeti90

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

continue

Do you know the correct answer?

A rectangular steel eyebar 3/4 inches thick and 24 ft long between centers of end pins is subjected...