Engineering, 23.03.2020 17:13, tay840

Shell- and-Tube Heat Exchanger to Heat Chicken Broth
A double-pipe HX operated in counter-current mode is used to heat chicken soup broth. The heat exchanger consists of a 2 in. schedule 80 stainless steel inside the pipe and a 4 in. schedule 40 stainless steel outside the pipe. The broth at 20oC enters the inside pipe at a volumetric flow rate of 10.0 L/min. and must exit at 80oC. The heating fluid is water which enters the shell side at 95oC and exits at 65oC. The overall heat transfer coefficient (U) and heat exchanger size (Area and Length) must be calculated.
Note: Assume the properties of the chicken broth are the same as water.
a. Sketch and completely label the process, including inlet and outlet streams. State all assumptions.
b. Sketch the expected temperature profile in the HX.
c. Calculate the overall heat transfer coefficient (U). Calculate and list separately all resistances. Which resistance is the dominant resistance to heat transfer?
d. Calculate the log-mean-temperature difference for the HX.
e. Calculate the required Area of the HX and Length of the double-pipe heat exchanger.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Engineering, 04.07.2019 19:10, kimmy6973

What is creep? what is stress relaxation?

Answers: 1

continue

Do you know the correct answer?

Shell- and-Tube Heat Exchanger to Heat Chicken Broth
A double-pipe HX operated in counter-cur...