Engineering
Engineering, 23.03.2020 16:31, Soccermen1021

You will recall that when we use the Extended Euclidean Algorithm to find the modulo inverse of a number, we must first apply the standard Euclidean Algorithm to find the equation number (starting from Equation 0) that has the last nonzero remainder. This tells us that the value we are looking for is the y-value whose index is two greater than this number (if this value is negative, we just add the modulus one time). For example, if the last nonzero remainder in the standard Euclidean Algorithm occurs in Equation 1, then the inverse value we are looking for is equal to the value of y3. You will also recall that we calculate the values of y as follows:

y0 = 0; y1 = 1; and for all i > 1, yi = yi-2 – (yi-1)(qi-2),

where qi is the quotient in the standard Euclidean Algorithm for Equation i. For example, y2 = y0– (y1)(q0).

Use the Extended Euclidean Algorithm to find the mod 72 inverse of 5. You must show all work to receive full credit.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
image
Engineering, 04.07.2019 18:10, genyjoannerubiera
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Do you know the correct answer?
You will recall that when we use the Extended Euclidean Algorithm to find the modulo inverse of a nu...

Questions in other subjects:

Konu
Mathematics, 04.08.2019 06:30