Engineering, 20.03.2020 11:00, hannah2757
The data declarations for the program below are done. Remembering that data can only be manipulated in registers, add data1 to data2. Then add that sum to data3. Multiply the resulting sum by data4, then subtract data 5 from that total. Finally, take the 2’s complement of the result, store this final result in ans, and output it to the console. Before you output the answer, output the leader declared below: "Answer = " . Then output the answer you have calculated. Remember that outputting a phrase uses syscall 4.
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, soreese02
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:20, rjone8429
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
Engineering, 04.07.2019 19:20, lovenahofer
Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?
Answers: 3
Do you know the correct answer?
The data declarations for the program below are done. Remembering that data can only be manipulated...
Questions in other subjects:
English, 20.05.2021 19:10
Mathematics, 20.05.2021 19:10
Arts, 20.05.2021 19:10
