Engineering
Engineering, 19.03.2020 20:04, leannaadrian

The following creep data were obtained for a titanium alloy at 50 ksi and 400 degrees C. (a) Plot the creep strain vs time (hours) and (b) determine the steady-state creep rate for the test conditionscol1 Strain (in/in) 0.010x10-2 0.030x10-2 0.050x10-2 0.075x10-2 0.090x10-2 0.11x10-2
col2 Time (hr) 2 18 40 80 120 160

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, mm016281
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Do you know the correct answer?
The following creep data were obtained for a titanium alloy at 50 ksi and 400 degrees C. (a) Plot th...

Questions in other subjects:

Konu
Mathematics, 30.10.2020 23:50
Konu
English, 30.10.2020 23:50