Engineering, 19.03.2020 01:46, lsizzle59

C&A's potato chip filling process has a lower specification limit of 9.5 oz. and an upper specification limit of 10.5 oz. The standard deviation is 0.2 oz. and the mean is 10 oz. The process capability index for the chip filling process is (round up to two decimal places).

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, danksans7011

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

continue

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Do you know the correct answer?

C&A's potato chip filling process has a lower specification limit of 9.5 oz. and an upper specif...