Engineering, 17.03.2020 00:58, Brandon4188

Two sections of a pressure vessel are to be held together by 5/8 in-11 UNC grade 5 bolts. You are told that the length of the bolts is 1.5 in, the length of the threaded portion of the bolts is 0.75 in, and that their elastic modulus is E=30 Mpsi. The total load on the joint is 36 kip and the stiffness of the members is given as km=8.95 Mlbf/in. What is the minimum number of bolts that should be used to guard against excess proof strength with a factor of safety of np=1.2? Be sure to make an estimate for the preload.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, abdirahmansoloman

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

continue

Engineering, 04.07.2019 18:10, dval1146

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Engineering, 04.07.2019 19:10, alex6toes

What are the major differences between injection molding and extrusion?

Answers: 2

continue

Do you know the correct answer?

Two sections of a pressure vessel are to be held together by 5/8 in-11 UNC grade 5 bolts. You are to...