Engineering, 16.03.2020 21:09, miner12924owhu4d

Pure aluminum is poured into a sand mold. The metal level in the pouring basin is 8 in. above the metal level in the mold, and the runner is circular with a 0.25 in diameter. The viscosity of the metal is 1.5e-07 lb-s/in2 and its density is 0.098 lb/in3.g = 32.2 ft/sec^2 a) Calculate the velocity of the metal when it gets into the mold. b) Calculate the flow rate of the metal when it gets into the mold. c) Calculate the Reynolds number (Re = velocitydiameter density/viscosity).

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

Do you know the correct answer?

Pure aluminum is poured into a sand mold. The metal level in the pouring basin is 8 in. above the me...