Engineering, 16.03.2020 18:55, bibi43232

In an IR detector, the sensor housing is held at 80 K by a mechanical cooler. The sensor is mounted to a frame that runs at 200 K by four thin walled hollow tubes that are 5.08 cm long by 1.27 cm outer diameter. The total heat leak through the four tubes into the detector has to be kept at less than 200 mW. Assuming G-10 (0.5 W/m-k) is used, find the wall thickness for the tube required to meet the heat leak condition. What if 6061-T6 (167.1 W/m-k) aluminum is used instead

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, mjcbs21

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

continue

Do you know the correct answer?

In an IR detector, the sensor housing is held at 80 K by a mechanical cooler. The sensor is mounted...