Engineering, 12.03.2020 05:37, AquaTyrant9232

A rigid bar ABCD is pinned at A and supported by two steel rods connected at B and C, as shown. There is no strain in the vertical rods before load P is applied. After load P is applied, the normal strain in rod (2) is 800 με. Determine : (ajthe axial normal strain in rod (1). b)the axial normal strain in rod (1) if there is a 1 mm gap in the connection between the rigid bar and rod (2) before the load is applied. 2.7 m 1.5 m Rigid bar 2.5 m

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Do you know the correct answer?

A rigid bar ABCD is pinned at A and supported by two steel rods connected at B and C, as shown. Ther...