Engineering, 12.03.2020 02:24, jaxheisjax532

Hot liquid is flowing in a steel pipe with an inner diameter of D, = 22 mm and an outer diameter of D2 = 27 mm. The inner surface of the pipe is coated with a thin fluorinated ethylene propylene (FEP) lining. The thermal conductivity of the pipe wall is 15 W/m. K. The pipe outer surface is subjected to a uniform flux of 1200 W/m2 for a length of 1 m. The hot liquid flowing inside the pipe has a mean temperature of 180°C and a convection heat transfer coefficient of 50 W/m².K. The interface between the FEP lining and the steel surface has a thermal contact conductance of 1500 W/m2.K. a) Determine the temperatures at the lining and at the pipe outer surface for the pipe length subjected to the uniform heat flux. b) What is the total thermal resistance between the two temperatures? c) The ASME Code for Process Piping (ASME B31.3-2014, A323) recommends a maximum temperature for FEP lining to be 204°C. d) Does the FEP lining comply with the recommendation of the code?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:20, sarah7984

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Engineering, 04.07.2019 19:10, nayi2002

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

continue

Do you know the correct answer?

Hot liquid is flowing in a steel pipe with an inner diameter of D, = 22 mm and an outer diameter of...