Engineering, 10.03.2020 22:35, mvtthewisdead

Two synchronous motors having subtransient reactances of 0.8 and 0.25 p. u., respectively, on a base of 500 V 2 MVA are connected to a bus. This motor bus is connected by a line having a reactance of 25 mΩ to a bus of a power system. At the power system bus the short circuit MVA of the power system is 12.5 MVA for a nominal voltage of 500 V. A symmetrical bolted three phase fault occurs at the motor terminals when the voltage at the motor bus is 450 V.
a) Calculate the fault current. Neglect the load current.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Do you know the correct answer?

Two synchronous motors having subtransient reactances of 0.8 and 0.25 p. u., respectively, on a base...