Engineering
Engineering, 10.03.2020 17:36, Heneyda

Waste dairy whey is used to grow Kluyveromyces fragilis yeast in a continuous culture system operated at 30C and 1 atm pressure. Medium containing 4% w/w lactose (C12H22O11) and 0.15% w/w NH3 flows into a specially designed aerated bioreactor at a rate of 200 kg h21. The reactor is compartmentalised to facilitate gravity settling of the yeast; a suspension containing concentrated cells is drawn off continuously from the bottom of the reactor at a rate of 40 kg h21, while an aqueous waste stream containing 0.5 kg cells per 100 kg leaves from the top. All of the lactose provided is utilised by the culture. The biomass yield from lactose is known from preliminary experiments to be 0.25 g g21. The composition of the K. fragilis biomass is determined by elemental analysis to be CH1.63O0.54N0.16 1 7.5% ash.

(a) What is the RQ for this culture?

(b) It is proposed to supply the reactor with air at a maximum flow rate of 305 litres min21.

Will this provide sufficient oxygen? If not, what minimum level of oxygen enrichment

of the air is needed if the total gas flow rate is 305 litres min21?

(c) What is the concentration of residual NH3 in the aqueous waste stream?

(d) What is the concentration of cells in the cell concentrate?

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, BardiFan
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
image
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Do you know the correct answer?
Waste dairy whey is used to grow Kluyveromyces fragilis yeast in a continuous culture system operate...

Questions in other subjects:

Konu
Mathematics, 19.11.2019 07:31