Engineering, 09.03.2020 03:39, 101shelsyroman

28. A high-pass filter passes signals with frequencies
that are higher than a certain cutoff frequency
In this filter the ratio of the magnitudes of the
voltages is given by:
R3
LEWRC
TIRE
where w=21ſ is the frequency of the input signal. Given R = 2,000 and
C =0,2 uF plot as a function of ſfor 10 <1 < 50,000 Hz. Use logarith-
mic scale for the horizontal (l) axis and linear scale for the vertical axis.
Note: mis labeled as “frequency" in the text, it is the angular frequency or angular
velocity in rad/s (o = 2nf where fis frequency in Hz).
Tips: 1. Use f-[10:10:50000]
2. 1 uF = 1.0e-6 F
In matlab

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:20, DroctorWellsfan

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

continue

Do you know the correct answer?

28. A high-pass filter passes signals with frequencies
that are higher than a certain cutoff f...