Engineering
Engineering, 07.03.2020 05:35, Chandler1Gaming

A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. The average values of the test results at four different test temperatures were found to be

10 ft. lb at 50 degrees F, 15 ft. lb at 0 degrees F, 40 ft. lb at 40 degrees F, 60 ft. lb at 100 degrees F.

The bridge will be located in a region where specifications require a minimum of 25 ft. lb fracture toughness at 30 degrees F for welded fracture-critical members. If the bridge contains a welded flange in a fracture-critical member, does the steel have adequate Charpy V notch fracture toughness? Show your supporting calculations.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
image
Engineering, 04.07.2019 18:10, juansoto227711
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Do you know the correct answer?
A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. The average values of th...

Questions in other subjects:

Konu
Mathematics, 04.02.2021 18:50
Konu
Mathematics, 04.02.2021 18:50
Konu
Mathematics, 04.02.2021 18:50