Engineering, 07.03.2020 01:36, erikasanchez2013

A balanced three-phase wye-connected generator has an internal impedance of 0.2 + j0.5 Ωper phase and the phase to neutral voltage is 220 V. The generator feeds a balanced three-phase wye-connected load having a load impedance of 10 + j8 Ωin each phase. The impedance of the line connecting the generator to the load is 0.2 + j0.8 Ωin each line. The a-phase internal voltage of the generator is specified as the reference phasor.1. Construct a phase equivalent circuit of the system.2. Calculate the line currents ILA, ILB, and ILC.3. Calculate the phase voltages at the load, VAN, VBN, and VCN.4. Calculate the line voltages VAC, VBC, and VCAat the load terminals.5. Calculate the phase voltages at the generator terminals, Van, Vbn, and Vcn.6. Calculate the line voltages at the generator terminals, Vab, Vbc, and Vca.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

Do you know the correct answer?

A balanced three-phase wye-connected generator has an internal impedance of 0.2 + j0.5 Ωper phase an...