Engineering, 07.03.2020 00:04, ggpro4life3000

A 2A-liter, four-cylinder engine is equipped with multipoint port fuel injection, having one injector per cylinder. The injectors are constant-flow devices, so the fuel flow rate into the engine is controlled by injection pulse duration. Maximum power is obtained at WOT when injection duration is continuous. At this condition, engine speed is 5800 RPM with stoichiometric gasoline and an inlet pressure of 101 kPa. At idle condition, the engine speed is 600 RPM with stoichiometric gasoline and an inlet pressure of 30 kPa. Volumetric efficiency can be considered 95% at all conditions. Calculate: (a) Fuel flow rate through an injector. [kg/sec] (b) Injection pulse duration in seconds at idle conditions. (c) Injection pulse duration in degrees of engine rotation at idle conditions.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

Engineering, 04.07.2019 18:20, safiyabrowne7594

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

continue

Do you know the correct answer?

A 2A-liter, four-cylinder engine is equipped with multipoint port fuel injection, having one injecto...