Engineering, 06.03.2020 23:45, bad32

You have an aluminum bar of dimensions 2cm5cm10 cm. You want to put it into electric circuit such a way that this bar will demonstrate the smallest possible resistance. You should connect your bar to the opposite faces with dimensions of:

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 06.07.2019 03:20, demotte79991

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

continue

Engineering, 06.07.2019 04:10, kathiewallentin1767

Steam enters a converging-diverging nozzle at 1.0 mpa and 500°c with a negligible velocity at a mass flow rate of 2.5 kg/s, and it exits at a pressure of 200 kpa. assuming the flow through the nozzle to be isentropic, determine: the exit area and (a) (b) the exit mach number

Answers: 2

continue

Engineering, 06.07.2019 04:30, josephvcarter

Describe briefly, the concept of mass production in modern industrial system.

Answers: 1

continue

Do you know the correct answer?

You have an aluminum bar of dimensions 2cm*5cm*10 cm. You want to put it into electric circuit such...