Engineering, 06.03.2020 00:07, aalichia

The portable lighting equipment for a mine is located 100 meters from its dc supply source. The mine lights use a total of 5 kW and operate at 120 V dc. Determine the required cross-sectional area of the copper wires used to connect the source to the mine lights if we require that the power lost in the copper wires be less than or equal to 5 percent of the power required by the mine lights.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 06.07.2019 05:20, yoyo2697

An ideal rankine cycle with reheat uses water as the working fluid. the conditions at the inlet to the high pressure turbine are 10mpa, 650°c and the steam is reheated at a constant pressure of 1.4mpa before entering the low pressure turbine. for a condenser pressure of 10kpa, plot the cycle thermal efficiency and quality of steam at the low pressure turbine exit versus reheat temperatures (the temp of steam entering the low pressure turbine) of 400, 500, and 600°c. draw the t-s diagram and show all your work for a reheat temperature of 400°c .note, there will be two plots. one with thermal efficiency on in the ordinate versus reheat temperate and the other will have quality on the ordinate versus reheat temperature. be sure to label all axes with variables and units and include title. the plots must be done on computer.

Answers: 2

continue

Do you know the correct answer?

The portable lighting equipment for a mine is located 100 meters from its dc supply source. The mine...