Engineering, 05.03.2020 14:26, rleiphart1

A stainless-steel billet (6 in. diameter, 1 ft long) is passing through a 20-ft-long heat-treating furnace. The initial billet temperature is 200°F, and it must be raised to a minimum temperature of 1500°F before working. The heat-transfer coefficient between the furnace gases and the billet surface is 15 Btu/h ft2 °F, and the furnace gases are at 2300 °F. (a) (3 pts) Draw a schematic of the problem. (b) (2 pts) State assumptions if you need to make any (c) (20 pts) At what minimum velocity must the billet travel through the furnace to satisfy these conditions?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:20, sarah7984

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:20, safiyabrowne7594

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

Do you know the correct answer?

A stainless-steel billet (6 in. diameter, 1 ft long) is passing through a 20-ft-long heat-treating f...