Flue passing hot exhaust gases has a square cross section, 400 mm to a side. The walls are constructed of refractory brick 200 mm thick with a thermal conductivity of 1.5 W/mK. Calculate the rate of heat loss from the flue per unit length when the interior and exterior surfaces are maintained at 350 and 25oC, respectively. Use a grid spacing of 100 mm

On a average work day more than work place firs are reorted

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.