Engineering
Engineering, 05.03.2020 11:13, cici170

The two aluminum rods AB and AC with diameters of 10 mm and 8 mm respectively, have a pin joint at an angle of 45.°
Determine the largest vertical force P that can be supported at the joint. The allowable tensile stress for the aluminum is 150 MPa.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 06.07.2019 03:10, lwattsstudent
List and describe in sequence the operation process steps for boxf machine?
Answers: 1
image
Engineering, 06.07.2019 03:20, shelbellingswo
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
image
Engineering, 06.07.2019 03:20, mardell2587
Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing
Answers: 3
Do you know the correct answer?
The two aluminum rods AB and AC with diameters of 10 mm and 8 mm respectively, have a pin joint at a...

Questions in other subjects: