Engineering, 05.03.2020 08:12, joshbee2014

A boost converter intends to convert a 5 V input into a 10 V output. Rated output power is 50 W. The specifications call for an output voltage of 10 V ± 0.1%, and the input current variation of no more than ± 01%. The switching frequency is 20 kHz.
(a) Select an inductor and capacitor to meet these specifications.
(b) Simulate the circuit in PSCAD. Calculate the input current and capacitor voltage ripple.
(c) Make comments on the results obtained. Is the current ripple and voltage ripple under ± 1% and 0.1% respectively?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:20, alexis9263

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

continue

Do you know the correct answer?

A boost converter intends to convert a 5 V input into a 10 V output. Rated output power is 50 W. The...