Engineering, 03.03.2020 18:02, thechameleonnaire

An engineer working in an electronics lab connects a parallel-plate capacitor to a battery, so that the potential difference between the plates is 240 V. Assume a plate separation of d 1.77 cm and a plate area of A-25.0 cm. when the battery is removed, the capacitor is plunged into a container of distilled water. Assume distilled water is an insulator with a dielectric constant of 80.0

(a) Calculate the charge on the plates (in pC) before and after the capacitor is submerged. (Enter the magnitudes.) before pC after Q pC
(b) Determine the capacitance (in F) and potential difference (in V) after immersion.
(c) Determine the change in energy (in nJ) of the capacitor nJ
(d) What If? Repeat parts (a) through (c) of the problem in the case that the capacitor is immersed in distilled water while still connected to the 240 V potential difference Calculate the charge on the plates (in pC) before and after the capacitor is submerged. (Enter the magnitudes.) before Q, - after Q Determine the capacitance (in F) and potential difference (in V) after immersion. pC pC Determine the change in energy (in nJ) of the capacitor. nJ

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Engineering, 04.07.2019 19:10, Destinationz

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

continue

Engineering, 04.07.2019 19:20, dndndndnxmnc

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

continue

Do you know the correct answer?

An engineer working in an electronics lab connects a parallel-plate capacitor to a battery, so that...