Engineering, 03.03.2020 17:30, pup88
A coal-fired power plant is burning bituminous coal that has an energy content of 12,000 Btu/lb. The power plant is burning the coal at a rate of 110 lb/s. The efficiency of the powerplant is 33%, which means that 67% of the total energy from the coal is lost as waste heat.
a. A new heat exchanger is installed that is capable of using 0.12% of the waste heat to heat an air stream for use in another process in the plant. The air enters the heat exchanger at a volumetric flow rate of 2,000 acfm at 298 K and 1 atm. Assuming the heat exchanger is 90% efficient (i. e., 90% of the heat supplied to the heat exchanger is transferred to the air stream), at what temperature will the air leave the heat exchanger, assuming an exit pressure of 1 atm? Use an average specific heat of 0.244 Btu/lb-°R.
b. What will be the volumetric flow rate of the gas leaving the heat exchanger (in units of acfm)?
c. If the air exiting the heat exchanger has a moisture content of 12% (v/v), what is the moisture-corrected dry flow rate (in units of dry standard cubic meters per minute) at STP (1 atm, 298 K)?
Answers: 2
b) 
c) 
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Do you know the correct answer?
A coal-fired power plant is burning bituminous coal that has an energy content of 12,000 Btu/lb. The...
Questions in other subjects:
Mathematics, 24.02.2022 15:30
Chemistry, 24.02.2022 15:30
