Engineering, 03.03.2020 07:09, layla07

13) Use the following command entries to draw a 2D AUTOCAD object:
20.-20; 30,20:0.10, 30,00,30; -140,0;0,50: 50,0:0,60:10, 0, 0,-100; 10,0,0,100; 30,0:0:-100: 10.0.0.100: 100-
0.-30: 10.0; 0,30; 30.0: 0,30; -40,0;0.-50; 50.0:0.10: -40.0:0.3040,0,0,70; -130.0:0.-70; -50.0-0.-100-200
20,-20; 30,20 press Center?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:20, 1230bering

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Do you know the correct answer?

13) Use the following command entries to draw a 2D AUTOCAD object:
20.-20; 30,20:0.10, 30,00,30...