Engineering, 03.03.2020 06:10, Bubbyd121503

4.62 A steady-state, finite-difference analysis has been performed on a cylindrical fin with a diameter of 12 mm and a thermal conductivity of 15W/m K. The convection process is characterized by a fluid temperature of 25°C and a heat transfer coefficient of 25W/m2 K. If the temperature of the first three nodes, separated by a spatial increment of delta x = 10 mm, are T0 =100 degree C, T1 =93.4 degree C, and T2 = 89.5 degree C, determine the fin heat transfer rate. Determine the temperature at the node 3, T3.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 19:10, babas97

What is a monomer? how do they form a ploymer from the view point of chemical bonding?

Answers: 1

continue

Do you know the correct answer?

4.62 A steady-state, finite-difference analysis has been performed on a cylindrical fin with a diame...