Engineering, 03.03.2020 04:31, davidebner2248

You are to design a digital communication system to transmit four multiplexed analog signals with bandwidths of 1200 Hz, 900 Hz, 300 Hz and 1500 Hz, respectively. Each analog signal is to be sampled at its own respective Nyquist rates and encoded using linear PCM. The maximum tolerable error for each sample is 1% of the signal's peak voltage (Vo).
(a) What is the minimum PCM word size (bits per sample) required?
(b) What is the minimum transmitted bit rate for each of the sampled signals?
(c) Assume the signals are multiplexed on a sample-by-sample basis (each PCM sample is considered a unit not to be divided between frames). If 10 bits per frame are added for synchronization, what is the minimum frame size required (bits)? How many samples from each signal are included in each frame?
(d) What is the transmitted frame rate of the frame defined in part (c) in frames per second? What is the overall transmitted bit rate of the multiplexed digital communication system (bits per second)?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Do you know the correct answer?

You are to design a digital communication system to transmit four multiplexed analog signals with ba...