Engineering, 03.03.2020 03:59, SoccerdudeDylan
Part A - Transmitted power A solid circular rod is used to transmit power from a motor to a machine. The diameter of the rod is D = 2.5 in and the machine operates at ω = 170 rpm . If the allowable shear stress in the shaft is 10.4 ksi , what is the maximum power transmissible to the machine? Express your answer with appropriate units to three significant figures.
Answers: 1
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:20, rjone8429
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Part A - Transmitted power A solid circular rod is used to transmit power from a motor to a machine....
History, 30.05.2021 09:00
Mathematics, 30.05.2021 09:00
History, 30.05.2021 09:00
Mathematics, 30.05.2021 09:00
Mathematics, 30.05.2021 09:00
Mathematics, 30.05.2021 09:00
Physics, 30.05.2021 09:00
Mathematics, 30.05.2021 09:00
Biology, 30.05.2021 09:00