Engineering, 28.02.2020 22:28, noname5359

Open the Cruise. java file. Pay attention to the variable names and the code for the constructors, accessors, and mutators, which have already been created by your development team. See below for where you will add code to finish the printCruiseDetails() method

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 19:10, ndaha

An external consultant recommends that a plant installs a bank of capacitors for power factor correction. this will reduce the peak electrical demand charges by an average of 93 kw every month. the plant current pays $13 per kw in peak demand charges. the capacitor bank will include 223 kw of fixed capacitors, and 183 of variable capacitors. the fixed capacitors cost $59 per kw, and the variable capacitors will cost $65 per kw. the consultant charges 21% of the equipment costs to install the capacitors. because this project will reduce the demand for the electric utility, they are prepared to provide a one-time rebate of $42 per kw of reduced demand. what is the simple payback period for this project (in years)?

Answers: 2

continue

Engineering, 04.07.2019 19:10, shayshay7874

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

continue

Engineering, 06.07.2019 03:30, aksambo4707

State the stress optic law in two dimension and obtain an expression for the same.

Answers: 2

continue

Engineering, 06.07.2019 04:10, neariah24

An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?

Answers: 2

continue

Do you know the correct answer?

Open the Cruise. java file. Pay attention to the variable names and the code for the constructors, a...