Engineering, 27.02.2020 05:22, goofy44

A steel (E=30x106 psi, =0.292) bar is 10" long and has a square cross-section 2" on a side. It is loaded in axial compression with uniformly distributed end loads of 120,000 pounds. (a) Determine the change in the bar's length, section side, and section diagonal. (b) If the bar is put into a square hole exactly 2" on a side in a body of infinite rigidity and then loaded with the same load, find the change in bar length and the contact pressure along the bar sides. Consider the interface between the bar and the rigid material to be frictionless. (c) Calculate the % change in density due to deformation for parts (a.) and (b.).

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:20, annette211pdd8v9

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

continue

Do you know the correct answer?

A steel (E=30x106 psi, =0.292) bar is 10" long and has a square cross-section 2" on a side. It is l...