Engineering, 27.02.2020 04:29, RainaJade6004
It is desired to increase the output of a spark-ignition engine (with a compression ratio of 8:1 and an inlet pressure 1.0 atm) by either: (1) raising the compression ratio from 8 to 11, or (2) increasing the inlet pressure from 1.0 atm to 1.8 atm Assume g = 1.3 and . Using the constant volume cycle as a model for engine operation, which procedure will give: a) The highest pressure in the cycle? b) The highest efficiency? c) The highest i. m.e. p.?
Answers: 2
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10, johnthienann58
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Do you know the correct answer?
It is desired to increase the output of a spark-ignition engine (with a compression ratio of 8:1 and...
Questions in other subjects:
English, 15.07.2019 14:10
