Engineering, 26.02.2020 18:05, Tyrant4life

A heat pump (working in a thermodynamic cycle mode) is to be used to heat a house during the winter. The house is to be maintained at 294 K at all times. The house is estimated to be losing heat at a rate of 135,000 kJ/h when the outside temperature drops to 268 K. If the heat pump under these conditions has a coefficient of performance of 4, (a) Determine the power required to drive this heat pump (b) Determine the rate at which heat is absorbed from the cold outdoor air Repeat the questions assuming the heat pump works in a reversible mode. You need to calculate the coefficient of performance under these conditions.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, qwertylol12345

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Do you know the correct answer?

A heat pump (working in a thermodynamic cycle mode) is to be used to heat a house during the winter....