Engineering
Engineering, 25.02.2020 20:26, tiwaribianca475

More basic concepts: alternative shapes of yield curves A yield curve is a graphical representation of the relationship between the yields and the maturities of securities issued by a given borrower in a given currency on a given date. The mathematical relationship between these two variables, the yield and the maturity, is called the term structure of interest rates, and the graphical relationship (plotted curve) is called the yield curve. A yield curve can exhibit a variety of shapes, and the general shapes have been given a specific name. Identify the name of the yield curve that matches the pattern described as follows:

(a) Long-term rates are greater than short-term rates.
(b) The yield curve exhibits a downward-sloping curve.
(c) Long-term rates are equal to short-term rates.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, kevin72836
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
image
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Do you know the correct answer?
More basic concepts: alternative shapes of yield curves A yield curve is a graphical representation...

Questions in other subjects:

Konu
Mathematics, 27.02.2020 18:56