Engineering, 25.02.2020 19:56, clarissa2006
A composite wall separates combustion gases at 2600 °C from a liquid coolant at 100 °C, with gas- and liquid-side convection coefficients of 50 and 1000 W/m^2K. The wall is composed of a 10-mm- thick layer of beryllium oxide on the gas side and a 20-mm-thick slab of stainless steel on the liquid side. The contact resistance between the oxide and the steel is 0.05 m^2K/W. What is the heat flux of the composite wall? Sketch the temperature distribution from the gas to the liquid.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, wirchakethan23
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10, krystabrewer3
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
Engineering, 04.07.2019 18:20, miguel454545
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Engineering, 06.07.2019 02:30, Nonniel0v3
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
Do you know the correct answer?
A composite wall separates combustion gases at 2600 °C from a liquid coolant at 100 °C, with gas- an...
Questions in other subjects:
Mathematics, 10.02.2021 22:50
Biology, 10.02.2021 22:50
