Engineering, 25.02.2020 17:27, queenfan1818
Each girder of the lift bridge is 180 ft long and simply supported at the ends. The design load for each girder is a uniform load of intensity 1.6 kips/ft. The girders are fabricated by welding three steel plates so as to form an I-shaped cross-section having section modulus S 3600 inΒ³.
What is the maximum bending stress Οβββ in a girder due to the uniform load?
Answers: 1
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 19:10, Calliedevore
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
Each girder of the lift bridge is 180 ft long and simply supported at the ends. The design load for...
English, 28.01.2022 06:30
Mathematics, 28.01.2022 06:30