Engineering, 25.02.2020 17:18, lex3340

The anchor shown is used to tie tower guy cables to the ground and is supported by a distributed force from the soil, which can be approximated as shown. The anchor also is subjected to the loads shown, where P1 = 5 kNand P2 = 3 kN . The anchor is made from aluminum with E = 69 GPa . It is a cylindrical rod with diameter d1 = 4 cm with three segments of length L = 2 m . One end of the rod is linearly tapered to a diameter of d2 = 2 cm.

a. Calculate the intensity of the reaction load, Po
b. Use the reaction found in Part A, po = 13 kN/m , and calculate the total change in length for the anchor.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lowkeyqueenk

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

continue

Do you know the correct answer?

The anchor shown is used to tie tower guy cables to the ground and is supported by a distributed for...