Engineering, 24.02.2020 23:34, ssuereichard

(20pts) Air T[infinity] = 10 °C and u[infinity] = 100 m/s flows over a flat plate. Assume that the density of air is 1.0 kg/m3 and the dynamics viscosity is 1.8 ×10-6 kg/m∙s. (a) Determine the velocity boundary layer thickness at, δ at x = 2 m (x indicates the distance from the leading edge of the plate). (b) Determine local friction coefficient at x = 2 m. (c) Determine the Nusselt number at x = 2 m. Assume that the velocity boundary layer thickness is the same as the thermal boundary layer thickness (δ = δT).

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, sanchez626

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

continue

Engineering, 04.07.2019 18:20, cdyshaylia55

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

continue

Engineering, 04.07.2019 19:10, alex6toes

What are the major differences between injection molding and extrusion?

Answers: 2

continue

Do you know the correct answer?

(20pts) Air T[infinity] = 10 °C and u[infinity] = 100 m/s flows over a flat plate. Assume that the d...