Engineering, 24.02.2020 22:45, lizzoone

You are part of the designing team for a new solar thermal power plant. The plant will use thermal energy storage to produce electricity both during the day (when the sun is shining) and at night (when the sun is not shining!). The chosen storage fluid will be a salt, sodium nitrate (NaNO3). The liquid salt circulates through the concentrated solar energy collectors (mirrors) and achieves a temperature of 623 °C. It is then stored in a cylindrical tank that is 9.1 m in height and 24 m in diameter. The salt stored in the tank is then used to produce 100 MW of electricity for 4 hours. The efficiency of the process is 93% (Wow!). What is the final temperature of the salt in the tank at the end of the electricity-generating process (in °C)? 744.12K = 470.97℃

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Do you know the correct answer?

You are part of the designing team for a new solar thermal power plant. The plant will use thermal e...