Engineering, 22.02.2020 01:06, eelebron0905

Given the following data, plot the stress-strain curves for the two unknown materials on the same set of stress-strain axes. Density4.43g/cm33.98g/cm3E114 GPa380 GPa0.340.22Yield stress (at 0.2% strain)830 MPaNot applicableUltimate tensile strength900 MPa550 MPaFailure stress840 MPa550 MPa% elongation14NegligibleWhat likely types are Materials A and B?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Do you know the correct answer?

Given the following data, plot the stress-strain curves for the two unknown materials on the same se...