Engineering, 21.02.2020 05:55, emrecaga1992

A large bypass ratio turbofan engine (JT9D engine from Pratt and Whitney, 1974) is described by its fan and core engine gas flow properties. (a) What is the overall pressure ratio (OPR) of this engine (b) Estimate the fan gross thrust Fc fan in lbf (c) Estimate the fuel-to-air ratio based on the energy balance across the burner, assuming the fuel heat- ing value is ~18,600 BTU/lbm and the specific heat at constant pressure is 0.24 and 0.26 BTU/Ibm . 'R at the entrance and exit of the burner, respectively (d) Calculate the core gross thrust and compare the sum of the fan and the core thrusts to the specified engine thrust of 43,500 lbf (e) Calculate the engine thermal efficiency and com- pare it to Problems 3.1-3.3. Explain the differences (f) Estimate the thrust-specific fuel consumption (TSFC), in lbm/h/Ibf (g) What is the bypass ratio of this turbofan engine

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 19:10, nbunny7208

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

continue

Engineering, 04.07.2019 19:10, Lexi5170

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b. s. and b. s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

continue

Do you know the correct answer?

A large bypass ratio turbofan engine (JT9D engine from Pratt and Whitney, 1974) is described by its...