Engineering
Engineering, 21.02.2020 04:16, yonna74

A refrigerator uses refrigerant-134a as the working fluid and operates on vapor-compression refrigeration cycle. The pressures of the evaporator and condenser are 0.12 MPa and 0.8 MPa, respectively. The isentropic efficiency of the compressor is 0.85. The mass flow rate of the refrigerant is 0.1 kg/s.

Assume that the refrigerator leaves the evaporator as saturated vapor, and leaves the condenser as saturated liquid, and disregard any heat transfer and pressure drops in the connecting lines between the components.

(1) Show the cycle on a T-s diagram with respect to saturation lines; and Determine

(2)the rate of heat removal from the refrigerated space;

(3) the power input to the compressor;

(4)the rate of heat rejection to the environment;

(5) the coefficient of performance (COP)

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:10, kayleeemerson77
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
image
Engineering, 04.07.2019 19:20, GusGus11
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
image
Engineering, 04.07.2019 19:20, ijohnh14
Apure substance is a)-mixture of various chemical elements or compounds b)-substance that has a fixed chemical composition throughout c)-mixture that is homogeneous (such as air) d)-all the answers
Answers: 3
image
Engineering, 04.07.2019 19:20, nikkiebartels
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer, e = 5 × 105?
Answers: 2
Do you know the correct answer?
A refrigerator uses refrigerant-134a as the working fluid and operates on vapor-compression refriger...

Questions in other subjects:

Konu
Engineering, 13.01.2021 07:30