Engineering, 21.02.2020 03:32, terabear2033

After being purged with nitrogen, a low-pressure tank used to store flammable liquids is at a total pressure of 0.03 psig. (a) If the purging process is done in the morning when the tank and its contents are at 55°F, what will be the pressure in the tank when it is at 85℉ in the afternoon? (b) If the maximum design gauge pressure of the tank is 8 inches of water, has the design pressure been exceeded? (c) Speculate on the purpose of purging the tank with nitrogen

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Do you know the correct answer?

After being purged with nitrogen, a low-pressure tank used to store flammable liquids is at a total...