Engineering, 20.02.2020 23:43, jmitial

A penstock 1 m in dimeter and 10 km long carries water from a reservoir to an impulse turbine. If the turbine is 83% efficient, what power can be produced by the system if the upstream reservoir elevation is 650 m above the turbine jet, and the jet dimeter is 16.0cm? Assume f=0.016, and neglect head losses in the nozzle. What should dimeter of the turbine wheel be if it is have an angular speed of 360 rpm? Assume ideal conditions for the bucket design ( = 1 2 )

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Engineering, 04.07.2019 19:10, alex6toes

What are the major differences between injection molding and extrusion?

Answers: 2

continue

Engineering, 06.07.2019 03:10, LouieHBK

Different between right hand turning tool and left hand turning tool ?

Answers: 1

continue

Do you know the correct answer?

A penstock 1 m in dimeter and 10 km long carries water from a reservoir to an impulse turbine. If th...