Engineering, 19.02.2020 22:58, keke6361

Determining the frequency of a voltage signal for a synchronous machine. a. Write the equation for a synchronous generator, which determines the frequency of the output voltage dependent upon the input shaft speed and the number of poles of the machine. b. If you are working at Stations 1 or 2, your synchronous machine has a rated speed of 1200 rpm; if you are working at Stations 3 or 4 your synchronous machine has a rated speed of 1800 rpm. Use the equation in part a. to determine the number of poles of your machine based on this nameplate information. c. With the number of poles determined in part b., determine the speed required to obtain the following frequencies: 15 Hz, 30 Hz, 45 Hz, 60 Hz, 70 Hz and 80 Hz

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 18:20, jessie8022

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

continue

Do you know the correct answer?

Determining the frequency of a voltage signal for a synchronous machine. a. Write the equation for a...