Engineering
Engineering, 19.02.2020 04:00, kautumn27

A wire of length L 5 4 ft and diameter d=0.125 in. is stretched by tensile forces P= 600 lb. The wire is made of a copper alloy having a stressstrain relationship that may be described mathematically by:. sigma = 18000 epsilon/1 + 300 A) Determine the stress on the wire due to the force P=1.B) Determine the strain, epsilon_p, in the wire due to the force epsilon P= 3pt . C) Determine the elongation. delta_L, of the wire in inch due to the force P delta_L= 1ptD) Determine the residual strain, epsilon_R, if the force P is removed, epsilon_R= 3pt. E) Determine the permanent set (or elongation) of the wire, delta_permanent= 2pt. F) What is the elastic strain recovery, epsilon_Recovery= 2pt. G) What length of wire was elastically recovered, delta_Elastic= 2pt. H) If the force is applied again, what is the proportional limit, on sigma_PL= 2pt. I) What is the toughness of the original wire assuming it breaks at a strain of 0.03. toughness= 4pt.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, aliceohern
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
image
Engineering, 04.07.2019 18:10, colin774
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
Do you know the correct answer?
A wire of length L 5 4 ft and diameter d=0.125 in. is stretched by tensile forces P= 600 lb. The wir...

Questions in other subjects:

Konu
Mathematics, 05.08.2021 17:30