Engineering
Engineering, 18.02.2020 18:37, rawbabyjazz

A copy of a Pepco Home Energy Report for Dr. Louie when living in Maryland from Mar 22 – Apr 21, 2016 is attached at the end of this assignment. The total energy use for heating over the 31-day period was 95 kWh (which was 53% lower than other "efficient" homes in the area). Assume the only heat loss is through the insulation along the walls, and there is no movement of air or other flow in or out of the system. The estimated surface area of walls in contact with the outdoor air and indoor air is 560 ft2 . Based on historical records, the average outdoor temperature during this period was around 51 °F. Assume the indoor air temperature was held at an average of 67 °F, and the system is at steady-state. Calculate the R value for the insulation in ft2 ·°F·h/Btu

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
image
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
image
Engineering, 04.07.2019 18:20, safiyabrowne7594
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Do you know the correct answer?
A copy of a Pepco Home Energy Report for Dr. Louie when living in Maryland from Mar 22 – Apr 21, 201...

Questions in other subjects:

Konu
Mathematics, 02.07.2019 03:00
Konu
English, 02.07.2019 03:00
Konu
Biology, 02.07.2019 03:00