Engineering
Engineering, 18.02.2020 18:03, mjessen119

This elementary problem begins to explore propagation delayand transmission delay, two central concepts in data networking. Consider two hosts A andB, connected by a single link of rate R bps. suppose that the two hosts are separated by mmeters, and supose the propagation speed along the link is s meters/sec. Host A is to send a packet ofsize L bits to Host B. a. Express the propagation delay d(prop) interms of L and R. b. Determine the trnasmission time of the packet d(trans) in termsof L and R. c. Ignoring processing and queing delays obtain an expression forthe end to end delay. d. Supose Host A begins to transmit packet at time t=0 . At timet=d(trans) where is the last bit of the packet. e. Suppose d(prop)is greater than d(trans) . At time t= d(trans)where is the first bit of the packetf. Suppose d(prop)is less than d(trans) . At time t= d(trans) whereis the first bit of the packetg. Suppose s=2.5* 10power(8), L=100 bits and R=28 kbps. find thedistance m so tha d(prop) equals d(trans).

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, jadeochoa4466
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
image
Engineering, 04.07.2019 18:10, yasminothman02
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Do you know the correct answer?
This elementary problem begins to explore propagation delayand transmission delay, two central conce...

Questions in other subjects:

Konu
Mathematics, 08.01.2020 11:31