Engineering, 18.02.2020 01:53, k3ydag0at

In orthogonal machining, the tool has a rake angle α = 10°, chip thickness before cut is 0.5 mm, chip thickness after cut is 1.15 mm and depth of cut is 3 mm. The cutting and thrust forces are measured at Fc = 1550 N and Ft = 1270 N, while the cutting speed is 60 m/min. Determine:

a. machining shear strain.
b. shear stress
c. cutting power
d. coefficient of friction between tool and chip (µ)
e. shear angle
f. shear force, Fs
g. chip velocity
h. shear velocity
i. MRR
j. specific energy
k. friction power
l. shear power
m. Gross power to operate the machine tool P, if the mechanical efficiency is 0.87.
n. draw the merchant’s circle by using a reasonable scale
p. resultant force, R
q. friction angle, ß

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Do you know the correct answer?

In orthogonal machining, the tool has a rake angle α = 10°, chip thickness before cut is 0.5 mm, chi...