Engineering, 17.02.2020 17:11, samariahmiddlebrooks

Write a pargraph ...
identify help desk job stressors. Based on your understanding of help desk operations a job tress, make a list of ten or more different factors in a help desk environment that can increase or decrease the job stress experienced by agents. Use the websites listed in the chapter as sources if you need ideas. Then organize the stressors into a few large categories. Compare our list with those developed by your colleagues. Do you have the same or different categories?
answer as a pargrahp please !

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 19:20, brae72

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

continue

Engineering, 06.07.2019 03:20, 1xXJOKERXx3

Areaction-bonded silicon nitride ceramic has a strength of 250 mpa and a fracture toughness of 3.4 mpa(m)^1/2, what is the largest-sized internal flaw that this material can support without fracturing? (use y -1 in the fracture-toughness equation.)

Answers: 3

continue

Engineering, 06.07.2019 05:10, leshia39

Agas contained in a piston-oylinder assembly is initially at p1=100 ibf/ft^2? and occupies a volume of 3.75 ft. the gas is compressed to a pressure p2=500 ibf/ft^2 and a final volume of 0.5 ft. during the process, the relationship between pressure and volume is given as p= a +bv, where a and b are constants a)-determine the values and units for a and b b)-determine the volume, in ft, at an intermediate state where the pressure is 300 ibt/t2.

Answers: 2

continue

Do you know the correct answer?

Write a pargraph ...
identify help desk job stressors. Based on your understanding of help des...